- Metal
- As shown in the image
- Type: M10
- Sizes are as shown on the image
- The silver T-shaped Puller with 18 Blue Spacers is 270 Grams, and the 18 Blue spacers are 50 Grams
- Red T-shaped puller 18 blue weight 130 grams
This kit can be used to repair paintless dents.
- 1. Use a wet, dry cloth to clean the dent.
- 2. The glue stick should be placed into the gluegun. Pull the trigger so that the glue sticks enters the gluegun. Switch on the electricity and heat for 5 minutes.
- 3. The larger the dent, the bigger the stretch washer.The greater the tension of the tension gasket the larger it is;
- 4. The gasket must be applied with the hot melt glue in the four holes.
- 5. Then, place the brush spacer that is coated in hot melt adhesive on the center of dent and gently press until it adheres. (Let the glue cool down for approximately 8 minutes). Cooling time in winter should not exceed 10 minutes.
- 6. Then, align the repair device in the shape of a T, apply hot melt glue to the drawing gasket, and slide the bar up.
- 7. You can tap the board lightly with crushed pen or hammer if the dent is persistent.
- 8. Use a wet, clean towel to wipe the patch.
- OPP bag packaging
- If you require an invoice, contact our customer service.